★AIX compression with TAR, COMPRESS, GZIP, ZCAT
tar
tar in AIX by default does not support compression. You will need to incorporate with gzip command to have it
tar and compress at the same time.
$ tar cvf test.tar test # pure tar only
$ tar cvf - test | gzip > test.tar.gz # tar and compress together
gzip / gunzip
$ gunzip -c test.tar.gz | tar tvf - # list compress files
$ gunzip -c test.tar.gz | tar xvf - # decompress files
★nmon command
nmon -fT -s DATAinterval(unit in seconds) -c NUMBERofExecutions
nmon -fT -s 1 -c 10800
→ Data will be recorded every 1 seconds
→ nmon data will be recorded : 1sec x 10800times = 3hours
★tcpdump
#Write an output file of tcpdump result
tcpdump -i en20 -w dumpfilename.out
tcpdump -w dumpfile
#Read the result of tcpdump
tcpdump -r dumpfilename.out
or
tcpdump -r dumpfilename.out > dumpfilename.out.result
more dumpfilename.out.result
★Check AIX Network Status
Network Interface
OVERVIEW and PROCEDURE
The task that is described in this procedure is performed in the AIX terminal window. If the terminal window
is not open at this time, you may do so by using the instructions in Hardware Management Console Overview.
After the terminal window is open, simply type
netstat -r
Where netstat = network status
-r = route
The primary information to check is located in the first entry in the top-left, “default”, and then the column
to the far right titled “If”. This column tells you what interface is being used. For instance, “en0”.
Secondarily, you may run an additional command to
entstat -dt en0
Where entstat = network settings
-dt = display all statistics
en0 = The interface from the If column
As a result of this command, the information that you should check is as follows:
Link Status : up Tells you that the cable is attached and is connected to a switch. In other words, the cable
from the system to the network is functional. This is a good thing!
NOTE: If the status is down (Link Status : down), there is a problem with the cable, or the switch, or the
port.
Media Speed Selected Should read “100 Mbps Full duplex”
Exception: If the machine has a gigabit card, it will read “Autonegotiate”
Media Speed Running Should read “100 Mbps Full duplex”
IF your system has a NIC / NIB (network interface backup) as en20, you may try the below command to check the
status of each primary and secondary network condition.
entstat -dt en20 | egrep “(Link Status|Media Speed)”
command result (sample):
Link Status: Up
Media Speed Selected : Autonegotiation
Media Speed Running : 1000 Mbps Full Duplex
Link Status: Up
Media Speed Selected : Autonegotiation
Media Speed Running : 1000 Mbps Full Duplex
Like this:
Like Loading...
Recent Comments